X Series
Cellphone / GPS Holder
Mounting the Cellphone/GPS Holder Unscrew the clamp lock and remove the rubber adapter pieces from inside the clamp. Put the clamp on the carts handle and tighten lock to secure. Attaching your Phone or Device Use the buttons on the back of the ...
Replacing the Rheostat on a BATCADDY X9R
Remove the lower two of three screws on the back of the carts handle, leaving the top screw in place. Remove the panel on the front of the handle to expose the circuit board and wiring. Remove the locknut that holds the rheostat in place. Remove the ...
Adjusting the Front Wheel Tracking for the BATCADDY X4,X8 and X9
Find the Tracking Mechanism The tracking mechanism can be found attached to the front axle on the right side of the cart. You can loosen or tighten the two nuts on the mechanism to adjust the tracking. Release the Handle Before adjusting the ...
Replacing the Wiring Harness on a BATCADDY X3,X4 or X8
1) Remove Face Plate - Use sharp Knife to get under edge of faceplate. 2) Remove small screw to release circuit board 3) Cut old wire - leave the colored wires in white connector for future reference. 4) Tape string to end of old wiring harness that ...
Replace Rear Axle on Carts w/ one Motor (Sport/Classic)
Tools: Hammer 1/8” metal punch Snap ring pliers 10mm wrench Small crescent wrench Philips head screwdriver 2.5 mm Allen wrench 1) On the end of the axle opposite the motor/gearbox. Punch out the axle pin. (hammer & punch) (May not be necessary if ...
Front Wheel Tracking Adjustment for X3 Series BATCADDY
Front Wheel Tracking Adjustment for X3 Series BATCADDY The front wheel of the BATCADDY can be adjusted to compensate for how the cart is balanced. Find The Tracking Mechanism For the X3 series BATCADDY there is a small thumb wheel next to the front ...
Replacing the Controller on your BATCADDY X3,X4 and X8
Finding the Controller The controller is located in a compartment below the battery. Flip over the cart, you will notice a couple of screws holding a panel in place. Once these are removed you can slide away the panel exposing the carts controller. ...
Remounting and Replacing Treads
Many Bat-Caddy front and rear wheels come with replaceable treads. If the treads have worn through to the plastic, or if the rubber has become exercised and does not fit snug to the wheel they will need to be replaced. When replacing or remounting ...
Scorecard and Umbrella Holder Assembly Instructions
Scorecard/Umbrella Holder Assembly Instructions 1. Unpack and Check Parts a. Mounting Bracket b. Allen Wrench c. Scorecard Holder & long Mounting Screw d. Umbrella Holder & short Mounting Screw 2. Open Mounting Bracket by loosening 2 Screws with ...
Seat Assembly & Installation (All Models)