Syncing your remote control unit to the EVO Golf Caddy
Syncing your remote control unit to the EVO Golf Caddy
1. Make sure Remote Control is fully charged.
2 Plug in battery
3 Turn on remote
4 Press and hold the 3 and 4 buttons on the remote (light on remote will turn magenta)
5 Press and hold the start/stop on the caddy (button lit blue on the back of handle)
6 Keep the start/stop button held down until it starts blinks rapidly. When rapid blinking begins, release start/stop button.
7 Start/stop on caddy will begin to blink slowly.
8 Once start/stop button on caddy is blinking slowly, press and hold start/stop button on caddy for about 3 seconds until it stops blinking
The remote should now be in sync with the cart.
Video Showing Sync
Related Articles
How to Assemble Scorecard Holder for BATCADDY EVO
EVO Scorecard Holder To assemble the EVO scorecard holder you will need the scorecard holder, accessory bracket and Allen key. First remove the locking bolt from the accessory bracket and attach the scorecard holder. Next separate the two sides of ...
BATCADDY EVO Umbrella Holder
The umbrella holder for the BATCADDY EVO is installed on the left side of the carts handle. The handle can be removed by turning it counter-clockwise Once the handle has been removed you can set aside the plastic spacer. Now match up the teeth on the ...
Folding The Front Wheel of The BATCADDY EVO
See Video Linked Below https://workdrive.zoho.com/file/tuz2x678294ac692b4024a5058bb772fdc200 Note: The BATCADDY EVO II does not include the tool shown above. We found this tool to be unnecessary and recommend using the bag support to depress the ...
Replacing the Controller on your BATCADDY X3,X4 and X8
Finding the Controller The controller is located in a compartment below the battery. Flip over the cart, you will notice a couple of screws holding a panel in place. Once these are removed you can slide away the panel exposing the carts controller. ...
Remounting and Replacing Treads
Many Bat-Caddy front and rear wheels come with replaceable treads. If the treads have worn through to the plastic, or if the rubber has become exercised and does not fit snug to the wheel they will need to be replaced. When replacing or remounting ...