Remounting and Replacing Treads

Remounting and Replacing Treads


Many Bat-Caddy front and rear wheels come with replaceable treads. If the treads have worn through to the plastic, or if the rubber has become exercised and does not fit snug to the wheel they will need to be replaced.


When replacing or remounting the tread, its best to use an adhesive. We have found that ShoeGoo works best among consumer products.


It is best to apply the adhesive after the wheel has been mounted. Peel back the tread slightly and add a dollop of adhesive every 4"-6" between the tread and wheel hub.


Note: The X3 front wheel is a foam wheel and does not have a replaceable tread

    • Related Articles

    • Folding The Front Wheel of The BATCADDY EVO

      See Video Linked Below https://workdrive.zoho.com/file/tuz2x678294ac692b4024a5058bb772fdc200 Note: The BATCADDY EVO II does not include the tool shown above. We found this tool to be unnecessary and recommend using the bag support to depress the ...

    • Front Wheel Tracking Adjustment for X3 Series BATCADDY

      Front Wheel Tracking Adjustment for X3 Series BATCADDY The front wheel of the BATCADDY can be adjusted to compensate for how the cart is balanced. Find The Tracking Mechanism For the X3 series BATCADDY there is a small thumb wheel next to the front ...

    • Adjusting the Front Wheel Tracking for the BATCADDY X4,X8 and X9

      Find the Tracking Mechanism The tracking mechanism can be found attached to the front axle on the right side of the cart. You can loosen or tighten the two nuts on the mechanism to adjust the tracking. Release the Handle Before adjusting the ...

    • Replacing the Rheostat on a BATCADDY X9R

      Remove the lower two of three screws on the back of the carts handle, leaving the top screw in place. Remove the panel on the front of the handle to expose the circuit board and wiring. Remove the locknut that holds the rheostat in place. Remove the ...

    • Replacing the Controller on your BATCADDY X3,X4 and X8

      Finding the Controller The controller is located in a compartment below the battery. Flip over the cart, you will notice a couple of screws holding a panel in place. Once these are removed you can slide away the panel exposing the carts controller. ...