How to Assemble Scorecard Holder for BATCADDY EVO
EVO Scorecard Holder
To assemble the EVO scorecard holder you will need the scorecard holder, accessory bracket and Allen key.
First remove the locking bolt from the accessory bracket and attach the scorecard holder.
Next separate the two sides of the accessory bracket by loosening the bolts on the end.
Then place the accessory bracket where you would like it mounted on the upper frame, and tighten the bolts to secure.
Related Articles
BATCADDY EVO Umbrella Holder
The umbrella holder for the BATCADDY EVO is installed on the left side of the carts handle. The handle can be removed by turning it counter-clockwise Once the handle has been removed you can set aside the plastic spacer. Now match up the teeth on the ...Scorecard and Umbrella Holder Assembly Instructions
Scorecard/Umbrella Holder Assembly Instructions 1. Unpack and Check Parts a. Mounting Bracket b. Allen Wrench c. Scorecard Holder & long Mounting Screw d. Umbrella Holder & short Mounting Screw 2. Open Mounting Bracket by loosening 2 Screws with ...Syncing your remote control unit to the EVO Golf Caddy
Syncing your remote control unit to the EVO Golf Caddy 1. Make sure Remote Control is fully charged. 2 Plug in battery 3 Turn on remote 4 Press and hold the 3 and 4 buttons on the remote (light on remote will turn magenta) 5 Press and hold the ...Front Wheel Tracking Adjustment for X3 Series BATCADDY
Front Wheel Tracking Adjustment for X3 Series BATCADDY The front wheel of the BATCADDY can be adjusted to compensate for how the cart is balanced. Find The Tracking Mechanism For the X3 series BATCADDY there is a small thumb wheel next to the front ...Replacing the Wiring Harness on a BATCADDY X3,X4 or X8
1) Remove Face Plate - Use sharp Knife to get under edge of faceplate. 2) Remove small screw to release circuit board 3) Cut old wire - leave the colored wires in white connector for future reference. 4) Tape string to end of old wiring harness that ...