BATCADDY Support | Home

• Tech Tip Videos

    • Recent Articles

    • Replacing the Rheostat on an X3, X4 or X8 Series BATCADDY

      The below instructions go over how to replace the rheostat on an X Series BATCADDY. All steps should be performed with the BATCADDYS battery unplugged. Finding the Circuit Board The rheostat is wired to the circuit board in the handle. To get to the ...
    • Programming Presets into the EVO Remote

      The EVO series BATCADDY comes with a programable remote control. You can change the preset speeds of the 1-4 buttons by following the steps below. Power on the cart and remote control. Set your cart to the desired speed using the up and down arrows ...
    • Cellphone / GPS Holder

      Mounting the Cellphone/GPS Holder Unscrew the clamp lock and remove the rubber adapter pieces from inside the clamp. Put the clamp on the carts handle and tighten lock to secure. Attaching your Phone or Device Use the buttons on the back of the ...
    • Replacing the Rheostat on a BATCADDY X9R

      Remove the lower two of three screws on the back of the carts handle, leaving the top screw in place. Remove the panel on the front of the handle to expose the circuit board and wiring. Remove the locknut that holds the rheostat in place. Remove the ...
    • Folding The Front Wheel of The BATCADDY EVO

      See Video Linked Below https://workdrive.zoho.com/file/tuz2x678294ac692b4024a5058bb772fdc200 Note: The BATCADDY EVO II does not include the tool shown above. We found this tool to be unnecessary and recommend using the bag support to depress the ...